Wood Stove Setup

The burner is set in the heat reflector/ ash keeper. The tri-pod is put in the center and hooked over the edge. A Vasoline Cotton Ball is placed at the bottom of the tripod. Small twigs are stacked inside the center ring leaning towards the bottom vents. Index figure size "logs" (with bark removed) are layed horizonally on top of tripod center support to within 1/2" of the top edge. Not blocking the top vents. This stacking method will boil 2c water in 3min. Lite the cotton ball from one of the vents in the bottom and place the windscreen infront of the vents around the heat reflector as shown in pic, not around the burner. You can keep the wood stove going by placing "logs" on the center support thru the deep V cut in the front. The small vents in the bottom should be facing the wind.