Canister stove & pot question

[swisscross]

I too put some heat shrink wrap on my titan kettle handles.

I used R/C silicone fuel line on the handles of my TK.
Works great.

[ScareBear]

I used R/C silicone fuel line on the handles of my TK.
Works great.

Hmmmm.....interesting. Thanks.

I am going to try some wire connector shrink wrap first, since I've got oodles of different sizes, colors and grades in the garage...

[HooKooDooKu]

No, that's Sugru. But frankly it doesn't help that much... still gets hot! Silicone tubing would be better, just gotta get some.

I think I used two layers of heat shrink... plus the simple act of messing with the handles seemed to have loosened them up a little so the the heat doesn't transfer as fast... So it worked for me.

[swisscross]

Hmmmm.....interesting. Thanks.

I am going to try some wire connector shrink wrap first, since I've got oodles of different sizes, colors and grades in the garage...

I bought a few different colors a few years ago just for the TK(not into R/C).

If the shrink wrap does not satisfy your expectations shoot me a PM.

[poolskaterx]

Over a year later I got my new set up!!!
I went with the BRS3000 ti stove (25g) and the evernew 760 FD pot with a DIY lid. Total cost was about $60 shipped to my door in 2 days!

Posted about the pot here: https://whiteblaze.net/forum/showthr...g-760-FD-2-5oz!!!

here is the link to the stove:https://whiteblaze.net/forum/showthr...st-impressions

Thank you all for your input and guidance. I appreciate all the combined experience that is found on whiteblaze!